A WORD, A WORLD
isothermal
释义
- n.
- 等温线
- adj.
- 等温线的
- 网络
- 等温的；恒温；恒温扩增法
展开详细释义
adj.
1.等温的,等温线的
2.〔物〕〔气〕等温的
3.恒温的
n.
1.等温线,恒温线
常用短语 8 组
- isothermal forging
- 恒温锻造
- isothermal quenching
- 等温淬火
- isothermal compression
- 等温压缩
- isothermal condition
- 等温情况；等温条件
- isothermal adsorption
- 等温吸附
- isothermal transformation
- 等温转变；恒温变态
- isothermal annealing
- 等温退火，再结晶退火
- isothermal process
- 等温过程
在例句中理解 35 句
Conclusions It is feasible to estimate emulsifiability to the method of isothermal curve of the surface(interfacial) tension .
结论乳化剂表（界）面张力等温线比较法用于评价乳化剂的乳化能力是可行的。
Autogenous deformation: the bulk deformation of a closed, isothermal cementitious material system not subjected to external forces.
自生变形：没有受到外力的，封闭的、等温的水泥胶结材料系统的总体变形。
The equilibrium solubility of AlN in austenite at different temperatures and its isothermal precipitation have been studied.
我们已经研究过在不同温度的奥氏体氮化铝的溶解度以及等温过程的沉淀物。
A non-isothermal kinetic model, which took account of the effect of microwave, was proposed to fit the experimental data.
提出的微波非等温磷矿分解反应动力学模型与实验结果很好地相符。
Under consideration of cost, it is therefore suggested to let the isothermal tempering process last just for 30 min in practical use.
因此在成本考量之下，实际应用只需要进行30分钟的恒温回火持时就已足够。
During the pumping cycle the gas is in intimate contact with the sealing liquid and compression is nearly isothermal.
在抽运周期内，气体会与密封液和几乎等温的压缩气体紧密接触。
The results show that the joint can be strengthened through near isothermal forging and gradient heat treatment.
结果表明：近等温锻造+梯度热处理能使焊接接头得到强化。
AIR DISTRIBUTION AND AIR DIFFUSION. LABORATORY AERODYNAMIC TESTING AND RATING OF AIR TERMINAL DEVICES IN A ISOTHERMAL AIR DISCHARGE.
空气的分配和扩散.等温空气喷孔.空气的动力学试验及其特性表示法
The principle of isothermal calorimetry, typical instrument (TAM Air) and its application in field of cement hydration have been described.
摘要介绍了等温量热法测量的原理、典型的仪器以及在水泥水化研究中应用所具有的特点。
MEMS; hot embossing; isothermal solidification; solid-liquid interdiffusion ; metallic micro-devices.
微机电；微热压成型；等温凝固；固液扩散；金属微形元件。
Reference Channel. On a thermocouple scanner card, the channel that measures the temperature of the isothermal block.
参考通道在热电偶扫描卡上，测量等温块温度的通道。
Isothermal forging a process currently used products, products, uniform microstructure, mechanical performance is good.
等温锻造目前用于产品的一次加工，产品微观结构均匀一致，力学性能良好。
The thermal damping is maximum for frequencies corresponding to pulsations that are somewhere between isothermal and adiabatic.
当脉动处于等温和绝热之间某个状态时，相应频率下的热阻尼是最大的。
Within less than 1 millisecond the steep-fronted shock wave has traveled some distance ahead of the isothermal region.
在不到1毫秒的时间内，陡直的冲击波波阵面已比等温区领先一段距离了。
Using the method of isothermal forging spheroidal graphite cast iron pipe of good quality can be produced.
利用等温锻造方法可生产优质的球墨铸铁管。
Compared the two cooling methods, the microstructure were more homogenization and diversity by isothermal cooling method.
对比两种冷却方式，等温冷却可以得到更为均匀和多样的层片组织。
Isothermal forging of semi-finished products are close to finished size, very small margin.
经等温锻造的半成品已经接近成品尺寸，余量很小。
The phase transformation and weight loss rate of ludwigite in oxidizing roasting were studied by DTA-TG, isothermal TG and XRD.
利用DTA-TG、恒温TG和XRD测试方法研究了硼铁矿氧化焙烧过程中的相变和失重率。
OBJECTIVE To establish the single time point isothermal experiments at constant humidity stability test of penicillin potassium.
目的建立青霉素钾的单点测定恒温恒湿稳定性试验方法。
The mechanical properties of nodular cast iron can be further improved by isothermal quenching.
等温淬火处理可进一步提高球墨铸铁的机械性能。
Rolling circle amplification (RCA) is an isothermal nucleic acid amplification method which is simple, rapid, highly sensitive and specific.
滚环扩增（RCA）是新近发展起来的一种恒温核酸扩增方法。
The non isothermal effects of gas absorption are presented with select set of parameters.
本文并讨论各设定参数对非恒温吸收程序的影响。
The influences of isothermal quenching temperature on the retained austenite and mechanical properties of ADI were studied.
研究了等温淬火温度对ADI中残余奥氏体及其力学性能的影响。
The three dimensional effect of natural convection on a mini scale isothermal plate in an enclosure is numerically studied.
研究了封闭空间内小尺度等温竖板自然对流的三维效应。
The dye sorption characteristics of carbonized sludge and activated carbon were studied by using isothermal adsorption experiments.
采用等温吸附实验，比较研究了活性炭和炭化污泥染料吸附特性。
Under the calefactive and isothermal conditions, the seepage flux increased nonlinearly as the pore pressure increased.
等温或升温情况下，渗流量随孔隙压力增加均呈现非线性递增关系。
The crystallization behavior of cocoa butter was investigated using DSC under non-isothermal environment.
采用DSC研究可可脂在非等温条件下的结晶行为。
Anisotropy of isothermal remanent magnetism is a recently developed technique for rock fabric study.
等温剩磁各向异性是一种新的磁组构研究方法。
Objective To investigate the influence of several factors on isothermal automated DNA sequencing.
目的探讨恒温DNA自动测序中几种因素对测序结果的影响。
The isothermal crystallization kinetics indicate that the graft group can accellerate the crystallization rate of PP, and doesn't . . .
等温结晶动力学的研究表明接枝物结晶的成核方式不发生改变。
And you know, you could have a reversible engine with lots and lots of steps, but you could always break them down into some sequence of adiabatic and isothermal steps.
你们知道，我们可以设计一个由，很多很多个,循环步骤的热机，但是总可以把它分割成,一系列的绝热,和等温过程。
As long as it's reversible, you know what the efficiency has to be, and in principle, you could break it down into a bunch of steps that you could formulate as isothermal and adiabatic.
只要这个循环过程是可逆的，你们知道效率是多少，从理论上说，可以将总过程,分解成一系列绝热,和等温的小过程。
This results agree with that of isothermal crystallization kinetics.
这一结果同等温结晶相一致。
A simple computational model for isothermal phase change problem was based on the enthalpy formulation.
基于焓法模型导出了一种求解等温相变问题的简单计算模型。
The effect of isothermal forging temperature on microstructure and mechanical properties of2B70 aluminum alloy was studied.
研究了不同等温锻造温度对2B70铝合金显微组织与力学性能的影响。